Anti trap protection override
WARNING: This page is about a different car, the 2019 Jaguar XE. However, it is still accessible from the selected car via links, so may be relevant.
In the event when closing the window, the window stops and reverses, this may be due to a blockage such as ice, damage in the glass guide or a misaligned seal, causing the anti trap function to operate. If there are signs of damage or other faults, the problem must be rectified before proceeding with the PDI checks.
NOTE:
If this procedure fails to remove the blockage, the anti trap feature will be lost and must be reset after the blockage is cleared or rectified.
If the stoppage is due to icing, the protection function may be overridden as follows:
- After the initial attempt to close the window, operate the close switch a second time.
- When the window has reversed from the blockage, operate the switch (within 10 seconds) until the window stops again (the window will not reverse on the third attempt).
- Immediately operate the close switch again. The window will now move up a short distance with increased force to override the blockage.
- Repeat the override action until the window has closed. Each time the window stops, the switch must be operated immediately (within 0.5 seconds) to initiate further override action.