Driveshaft - INGENIUM I4 2.0L Petrol (G2028369): Installation

WARNING: This page is about a different car, the 2020 Jaguar XE and 2019 Jaguar XE. However, it is still accessible from the selected car via links, so may be relevant.

WARNING: This requires the aid of another technician.
- Install the driveshaft.
- Install the 2 bolts.
Renew Part: Driveshaft center bearing mount bolt(s) Quantity: 2.

Torque : 47.5Nm
- Make sure that you re-align the driveshaft to the differential output flange using the alignment mark.
- Install the 6 output flange bolts.
Renew Part: Driveshaft flange bolts Quantity: 6.

Torque : 75Nm
- Make sure that you re-align the driveshaft to the transmission flange using the alignment mark.
- Install the 6 rear differential bolts.
Renew Part: Driveshaft to rear differential bolts Quantity: 6.

Torque : 75Nm
- Install the heatshield.
- Install the 2 clips.
- Install the 4 bolts.
Torque : 9Nm
Install the exhaust system.
Refer to: EXHAUST SYSTEM
Reset the emergency park release cable.
Install the engine cover.
Refer to: ENGINE COVER - INGENIUM I4 2.0L PETROL