Post Catalyst Heated Oxygen Sensor (G2271369): Removal

WARNING: This page is about a different car, the 2020 Jaguar XE and 2019 Jaguar XE. However, it is still accessible from the selected car via links, so may be relevant.

WARNING: Observe due care when working near a hot exhaust system.

NOTE:

This procedure contains some variation in the illustration depending on the vehicle specification, but essential information is always correct.
This procedure contains illustrations showing certain components removed to provide extra clarity.

Disconnect the startup battery ground cable.
Refer to: STARTUP BATTERY DISCONNECT AND CONNECT .
Remove the engine cover.
Refer to: ENGINE COVER - INGENIUM I4 2.0L PETROL .
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Disconnect the post catalyst heated oxygen sensor electrical connector.
Raise and support the vehicle on a suitable 2 post lift.
Refer to: LIFTING .
Remove the air deflector.
Refer to: ENGINE UNDERSHIELD .
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Release the clips.
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Using the special tool, remove the post catalyst heated oxygen sensor.

Special Tool(s): JLR-303-1666