LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2019 >> XF S >> Repair and Diagnosis >> External Pages >> Different car >> Section 192 (Electronic Engine Controls - INGENIUM I4 2.0L Petrol -- XE/(760)) >> Electronic Engine Controls - INGENIUM I4 2.0L Petrol (G2006487) >> Removal And Installation >> Post Catalyst Heated Oxygen Sensor (G2271369) >> Installation

Post Catalyst Heated Oxygen Sensor (G2271369): Installation

WARNING: This page is about a different car, the 2020 Jaguar XE and 2019 Jaguar XE. However, it is still accessible from the selected car via links, so may be relevant.
    • Using the special tool, install the post catalyst heated oxygen sensor.

      Special Tool(s): JLR-303-1666 

      Torque  : 48Nm 

    • If the sensor is not being replaced with a new component. Make sure that a suitable anti seize grease is applied to the sensor thread.
  2. Install the clips.
  3. Connect the post catalyst heated oxygen sensor electrical connector.
  4. Install the air deflector.

    Refer to: ENGINE UNDERSHIELD .

  5. Install the engine cover.

    Refer to: ENGINE COVER - INGENIUM I4 2.0L PETROL .

  6. Connect the startup battery ground cable.

    Refer to: STARTUP BATTERY DISCONNECT AND CONNECT .

scientia non olet · About LEMON Manuals