Intake Camshaft Position Sensor (G2020274): Installation

WARNING: This page is about a different car, the 2020 Jaguar XE and 2019 Jaguar XE. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Apply a thin film of Castrol Classic GP-50 to the camshaft position sensor bore.
- Install the intake camshaft position sensor.
  Renew Part: Camshaft position sensor O-ring seal Quantity: 1 .
- Install and tighten the bolt.
  Torque : 8Nm
- Connect the electrical connector.
- Connect the breather pipe.
Install the engine cover.
Refer to: ENGINE COVER - INGENIUM I4 2.0L PETROL .
Connect the startup battery ground cable.
Refer to: SPECIFICATIONS .