Fuel Rail Pressure Sensor (G2289191): Removal
WARNING: This page is about a different car, the 2020 Jaguar XE and 2019 Jaguar XE. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
- Extreme cleanliness must be exercised when handling these components. Make sure that all tools and the surrounding area is clean before commencing work.
- Before disconnecting any components, make sure the area is clean and free from foreign material. When disconnected all openings must be sealed.
NOTE:
- This procedure contains some variation in the illustrations depending on the vehicle specification, but the essential information is always correct.
- This procedure contains illustration showing certain components removed to provide extra clarity.
- Before working on the fuel system make sure to study the fuel system health and safety information.
Refer to: PETROL AND PETROL-ETHANOL FUEL SYSTEMS HEALTH AND SAFETY PRECAUTIONS .
- Disconnect the startup battery ground cable.
Refer to: SPECIFICATIONS .
- Remove the engine cover.
Refer to: ENGINE COVER - INGENIUM I4 2.0L PETROL .
Disconnect the electrical connector from the fuel rail pressure sensor.
Remove the fuel rail pressure sensor.