LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2019 >> XF S >> Repair and Diagnosis >> External Pages >> Different car >> Section 192 (Electronic Engine Controls - INGENIUM I4 2.0L Petrol -- XE/(760)) >> Electronic Engine Controls - INGENIUM I4 2.0L Petrol (G2006487) >> Removal And Installation >> Front Knock Sensor (G2031025) >> Removal

Front Knock Sensor (G2031025): Removal

WARNING: This page is about a different car, the 2020 Jaguar XE and 2019 Jaguar XE. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
  • This procedure contains some variation in the illustrations depending on the vehicle specification, but the essential information is always correct.
  • This procedure contains illustrations showing certain components removed to provide extra clarity.
  1. Disconnect the startup battery ground cable.

    Refer to: SPECIFICATIONS .

  2. Raise and support the vehicle on a suitable 2 post lift.

    Refer to: LIFTING .

  3. Remove the generator.

    Refer to: GENERATOR .

  4. G11308594Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

    Disconnect the electrical connector.

  5. G11308595Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

    Remove the knock sensor.

scientia non olet · About LEMON Manuals