Fuel Tank (G1901946): Installation
WARNING: This page is about a different car, the 2020 Jaguar XE and 2019 Jaguar XE. However, it is still accessible from the selected car via links, so may be relevant.
The following step(s) applies to:
All vehicles
Make sure that all the O-ring seals are correctly installed before connecting the fuel supply line connectors.
- Install the fuel pump and sensor unit.
Refer to: LOW PRESSURE FUEL PUMP ASSEMBLY
Refer to: LOW PRESSURE FUEL PUMP ASSEMBLY
The following step(s) applies to:
Vehicles with fuel fired heater
-
- Connect the fuel pipe.
- Install the fuel pipe to the 5 clips.
The following step(s) applies to:
All vehicles
-
- Connect the 2 fuel pipes.
- Install the 2 fuel pipes to the 4 clips.
- Using a suitable support, raise the fuel tank.
- Connect the 2 electrical connectors.
- Connect the fuel pipe.
- Install the 2 brackets and finger tighten the 4 nuts.
- Tighten the 4 nuts.
Torque : 25Nm
The following step(s) applies to:
Vehicles with fuel fired heater
- Connect the 2 fuel pipes.
-
- Connect the fuel pipe.
- Install the clip.
The following step(s) applies to:
All vehicles
- Connect the 2 fuel pipes.
- Install the fuel tank shield and the 5 nuts.
- Install the 2 fuel tank shields and the 2 nuts.
-
- Connect the fuel filler pipe.
- Install and tighten the clamp.
-
NOTE: Repeat the step for the other side.
- Install the undershield and the 15 bolts.
- Install and tighten the 2 nuts.
-
NOTE: Repeat the step for the other side.
Install the mudflap and the 3 bolts.
- Install the driveshaft.
Refer to: DRIVESHAFT - INGENIUM I4 2.0L PETROL
Refer to: DRIVESHAFT - V6 S/C 3.0L PETROL
- Connect the startup battery ground cable.
Refer to: STARTUP BATTERY DISCONNECT AND CONNECT
- Fill the fuel tank with the amount recovered during the fuel tank drain procedure.