LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2019 >> XF S >> Repair and Diagnosis >> External Pages >> Different car >> Section 188 (Fuel Tank And Lines - INGENIUM I4 2.0L Petrol -- XE/(760)) >> Fuel Tank And Lines - INGENIUM I4 2.0L Petrol (G2006682) >> Removal And Installation >> Fuel Supply Line (G1900185) >> Installation

Fuel Supply Line (G1900185): Installation

WARNING: This page is about a different car, the 2020 Jaguar XE and 2019 Jaguar XE. However, it is still accessible from the selected car via links, so may be relevant.
  1. G11314839Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

    Make sure that all the O-ring seals are correctly installed before connecting the fuel supply line connectors.

  2. Install the fuel supply line to the vehicle.
  3. Connect the 2 fuel supply line connectors to the engine.
  4. Install the upper fuel supply line bracket to body bolt.

    Torque  : 7Nm 

  5. Connect the 2 wiring harness clips to the upper fuel supply line bracket.
  6. Connect the fuel supply line to body clip.
  7. Install the fuse box if previously removed.

    Torque  : 7Nm 

  8. Install the body brace and fuel supply line rubber mounting.

    Torque  : 55Nm 

  9. Install the cowl vent screen.
  10. Install the windshield wiper pivot arms.

    Refer to: WINDSHIELD WIPER PIVOT ARM

  11. Raise the vehicle on the lift to an appropriate working height.
  12. Connect the 2 fuel supply line connectors to the underbody fuel lines.
  13. Install the lower fuel supply line mounting bracket nut.

    Torque  : 7Nm 

  14. Install the wiring harness clip to the lower fuel supply line mounting bracket.
  15. Install the front left fender splash shield.

    Refer to: FRONT WHEEL ARCH LINER - PROJECT 8

  16. Lower the vehicle to the floor.
  17. Connect the battery ground cable.

    Refer to: STARTUP BATTERY DISCONNECT AND CONNECT

  18. Bleed the fuel system.

    Refer to: FUEL SYSTEM BLEEDING

scientia non olet · About LEMON Manuals