LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2019 >> XF S >> Repair and Diagnosis >> External Pages >> Different car >> Section 184 (Seating -- XE/(760)) >> Seating (G2260444) >> Removal And Installation >> Lumbar Assembly - Project 8 (G2260431) >> Installation

Lumbar Assembly - Project 8 (G2260431): Installation

WARNING: This page is about a different car, the 2020 Jaguar XE and 2019 Jaguar XE. However, it is still accessible from the selected car via links, so may be relevant.
    • Install the lumber assembly to the back cover.
      NOTE: Make sure the pipes are fully fitted into the back cover.

    Secure the lumber pipes to the lumber back cover.

  2. Install the lumber assembly 2. to the seat.
  3. Install the 2 clips.
    4. NOTE: Make sure the wiring harness is fully fitted into the back cover.
    • Secure the wiring harness to the lumber back cover.
    • Connect the electrical connector.
  5. Install the adhesive tape.
  6. Install the 6. lumber pump clip.
  7. Connect the electrical connector to the lumber pump.
    • Install the clip.
    • Install the grommet.
  9. Install the 2 upper clips.
  10. NOTE: Repeat the step for the other side.

    Install the clip.

  11. Install the front seat backrest cover.

    Refer to: FRONT ROW SEAT BACKREST COVER TRIM PANEL - PROJECT 8 

  12. Connect the startup battery ground cable.

Refer to: STARTUP BATTERY DISCONNECT AND CONNECT

scientia non olet · About LEMON Manuals