Front Seat Recliner Motor - Project 8 (G2263761): Installation

WARNING: This page is about a different car, the 2020 Jaguar XE and 2019 Jaguar XE. However, it is still accessible from the selected car via links, so may be relevant.

- Install the front seat recliner motor.
- Install and tighten the 4 bolts.
Torque : 50Nm
- Connect the electrical connector to the recliner motor.
- Install the clip.
- Move the wiring harness into the correct position.
- Install the 2 clips.
- Install the adhesive tape.
- Move the wiring harness into the correct position.
- Install the clip.
- Install the grommet.
Install the lumbar assembly.
Refer to: LUMBAR ASSEMBLY - PROJECT 8
Connect the startup battery ground cable.

Refer to: STARTUP BATTERY DISCONNECT AND CONNECT