Pinpoint Test E: Front Seat Tilt And/Or Seat Extension Motor Movement Not Functioning

WARNING: This page is about a different car, the 2020 Jaguar XE and 2019 Jaguar XE. However, it is still accessible from the selected car via links, so may be relevant.

E1: CHECK FRONT SEAT TILT OR EXTENSION MOTOR

WARNING:

Before work is completed, make the airbag supplemental restraint system safe. For additional information, refer to Standard Workshop Practices article of repair information
When carrying out the following steps, stand clear of all moving parts and make sure link harness is routed accordingly

Set ignition status to ' OFF'
Disconnect front seat tilt or extension motor connector
NOTE: It may be that the seat has been driven to the limit of travel along the relevant axis, and when the link harness is connected, the seat will remain in the same position. If this is the case, a jolt may be felt from the motor. To confirm the motor operation, swap the link harness to alternate motor pin connections and the seat should travel in the opposite direction
Using a locally made fused link harness and power supply, connect power and ground to relevant motor

BATTERY POSITIVE TERMINAL	BATTERY NEGATIVE TERMINAL
motor pin 1	motor pin 2

Does the motor operate?

Yes

Using the Jaguar Land Rover approved diagnostic equipment, perform routine - Calibration Run (0x205F). Using the Jaguar Land Rover approved diagnostic equipment, check for related Diagnostic Trouble Code(s) and complete the repair operations specified. Alternatively, refer to the electrical circuit diagrams and check relevant motor circuits

Replace the relevant motor. Refer to relevant article of repair information