LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2019 >> XF S >> Repair and Diagnosis >> External Pages >> Different car >> Section 182 (Engine Cooling - V8 S/C 5.0L Petrol, Project 8 -- XE/(760)) >> Engine Cooling - V8 S/C 5.0L Petrol, Project 8 (G2261486) >> Removal And Installation >> Thermostat Housing (G2244106) >> Installation

Thermostat Housing (G2244106): Installation

WARNING: This page is about a different car, the 2019 Jaguar XE. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the thermostat housing. Install and tighten the bolt.

    Torque  : 10Nm 

  2. Connect the 2 upper coolant hoses to the thermostat housing.
    • Connect the electrical connector and secure the 2 wiring harness clips.
    • Connect the 2 lower coolant hoses to the thermostat housing.
  4. Connect the 2 coolant hoses to the charge air cooler and secure the clip.
  5. Install the left air filter.

    Refer to: LEFT AIR FILTER HOUSING

  6. Install the air filter outlet pipe T-connector.

    Refer to: AIR FILTER OUTLET PIPE T-CONNECTOR

  7. Vacuum fill the cooling system.

    Refer to: COOLING SYSTEM PARTIAL DRAINING AND VACUUM FILLING 

scientia non olet · About LEMON Manuals