LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2019 >> XF S >> Repair and Diagnosis >> External Pages >> Different car >> Section 182 (Engine Cooling - V8 S/C 5.0L Petrol, Project 8 -- XE/(760)) >> Engine Cooling - V8 S/C 5.0L Petrol, Project 8 (G2261486) >> Removal And Installation >> Rear Coolant Manifold (G2368793) >> Installation

Rear Coolant Manifold (G2368793): Installation

WARNING: This page is about a different car, the 2019 Jaguar XE. However, it is still accessible from the selected car via links, so may be relevant.
  1. NOTE: This step is only required if new components are not installed.

    Install 2 new O-ring seals to the rear coolant manifold.

    Renew Part: Cylinder block coolant outlet O-ring seals  Quantity: 2. 

    • Install the rear coolant manifold.
    • Install and tighten the 4 bolts.

    Torque  : 9Nm 

    • Connect the electrical connector.
    • Install the wiring harness clip.
    • Connect the rear coolant manifold left hose.
    • Install the coolant hose clip.
  5. Connect the rear coolant manifold right hose.
  6. Install the secondary bulkhead left outer panel.

    Refer to: SECONDARY BULKHEAD LEFT OUTER PANEL - PROJECT 8

  7. Install the secondary bulkhead right outer panel.

    Refer to: SECONDARY BULKHEAD RIGHT OUTER PANEL - PROJECT 8

  8. Vacuum fill the coolant system.

    Refer to: COOLING SYSTEM PARTIAL DRAINING AND VACUUM FILLING 

scientia non olet · About LEMON Manuals