LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2019 >> XF S >> Repair and Diagnosis >> External Pages >> Different car >> Section 181 (Exhaust System - V8 S/C 5.0L Petrol Project 8 -- XE/(760)) >> Exhaust System - V8 S/C 5.0L Petrol, Project 8 (G2296809) >> Removal And Installation >> Left Catalytic Converter (G2244166) >> Installation

Left Catalytic Converter (G2244166): Installation

WARNING: This page is about a different car, the 2019 Jaguar XE. However, it is still accessible from the selected car via links, so may be relevant.
  1. NOTE: If the sensor is not being replaced with a new component. Make sure that a suitable anti seize grease is applied to the sensor thread.

    Using the special tool install and tighten the 2 Heated Oxygen Sensors (HO2S).

    Special Tool(s): 310-121 

    Torque  : 48Nm 

    • Install the catalytic converter.
    • Install and tighten the 2 nuts.

    Torque  : 40Nm 

    • Connect the electrical connector.
    • Install the 2 wiring harness clips.
    • Connect the electrical connector.
    • Install the wiring harness clip.
    • Install the heatshield.
    • Install and tighten the 3 bolts.

    Torque  : 12Nm 

  6. Install the front muffler.

    Refer to: EXHAUST SYSTEM CENTER SECTION 

  7. Install the engine undershield.

    Refer to: ENGINE UNDERSHIELD - PROJECT 8

scientia non olet · About LEMON Manuals