Exhaust System: Removal
WARNING: This page is about a different car, the 2019 Jaguar XE. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
- Removal steps in this procedure may contain installation details.
- Some components shown removed for clarity.
- Some variation in the illustrations may occur, but the essential information is always correct.
The following step(s) applies to:
All vehicles
-
WARNING: Make sure to support the vehicle with axle stands.
Raise and support the vehicle.
- Refer to: ENGINE UNDERSHIELD - PROJECT 8
The following step(s) applies to:
2WD vehicles
The following step(s) applies to:
4WD vehicles
The following step(s) applies to:
All vehicles
Torque : 40Nm
-
CAUTION: Make sure that the exhaust system is supported with suitable retaining straps.NOTE: Repeat the step for the other side.
Torque : 30Nm
The following step(s) applies to:
2WD vehicles
-
NOTE: Do not disassemble further if the component is removed for access only.
Torque : 48Nm
The following step(s) applies to:
4WD vehicles
-
NOTE: Do not disassemble further if the component is removed for access only.
Torque : 48Nm
The following step(s) applies to:
All vehicles
-
CAUTION: Make sure that new bolts are installed.
Renew Part: Exhaust pipe insulator bolts Quantity : 2.
Torque : 22Nm