Oil Pump (G1997945): Removal

WARNING: This page is about a different car, the 2020 Jaguar XE and 2019 Jaguar XE. However, it is still accessible from the selected car via links, so may be relevant.

NOTE:

This procedure contains some variation in the illustrations depending on the vehicle specification, but the essential information is always correct.
This procedure contains illustrations showing certain components removed to provide extra clarity.

Raise and support the vehicle on a suitable 2 post lift.
Refer to: LIFTING
Disconnect the startup battery ground cable.
Refer to: STARTUP BATTERY DISCONNECT AND CONNECT
Remove the oil pump chain.
Refer to: OIL PUMP CHAIN
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Disconnect the oil pump electrical connector.
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Release the connector from the engine and release the wiring from the retaining clip.
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
- Release the 2 retaining clips and remove the 5 retaining bolts.
- Remove the oil pump.
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Inspect the seal, replace if damaged.
NOTE: Do not disassemble further if the component is removed for access only.

Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Remove the 2 bolts and remove the oil pick-up pipe.