Lower Timing Cover (G1998105): Removal

WARNING: This page is about a different car, the 2020 Jaguar XE and 2019 Jaguar XE. However, it is still accessible from the selected car via links, so may be relevant.

NOTE:

This procedure contains some variation in the illustration depending on the vehicle specification, but essential information is always correct.
This procedure contains illustrations showing certain components removed to provide extra clarity.

Raise and support the vehicle on a suitable 2 post lift.
Refer to: JACKING
Disconnect the startup battery ground cable.
Refer to: STARTUP BATTERY DISCONNECT AND CONNECT
Remove the crankshaft rear oil seal.
Refer to: CRANKSHAFT REAR SEAL
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Remove the coolant pipe bracket.
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Remove the crankshaft position sensor (CKP).
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Remove the 2 dowel locating bolts.
CAUTION: Take extra care not to damage the surrounding components.

Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
- Remove the remaining 14 bolts.
- Remove the lower timing chain cover.
CAUTION: Take extra care not to damage the surrounding components.

Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Use a suitable tool to position the dowels as shown in the illustration.
Use a suitable scraping tool to Make sure that all traces of the old sealant are removed from the mating faces.