Crankshaft Rear Seal (G2110219): Installation

WARNING: This page is about a different car, the 2020 Jaguar XE and 2019 Jaguar XE. However, it is still accessible from the selected car via links, so may be relevant.

CAUTION: Make sure that the area around the component is clean and free of foreign material.

Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Install the first part of the special tool.

Special Tool(s): JLR-303-1674A
CAUTION: If the crankshaft rear seal (1) is removed from the provided spacer (2) prior to installation, a new seal must be installed.

Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
- Install the crankshaft rear seal (1) and the provided spacer (2) to the special tool.
Renew Part Crankshaft rear seal Quantity: 1.
- Position the crankshaft rear seal (1) in the correct location.
- Remove and discard the spacer (2).
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
- Install the second part of the special tool.
Special Tool(s): JLR-303-1674A
- Install and tighten the bolt.
- Remove the bolt.
- Remove the special tools.
Install the drive plate. Refer to: FLEXPLATE
Connect the startup battery ground cable.
Refer to: STARTUP BATTERY DISCONNECT AND CONNECT