Thermostat (G1796011): Removal
WARNING: This page is about a different car, the 2019 Jaguar XE. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
- Removal steps in this procedure may contain installation details.
- Some variation in the illustrations may occur, but the essential information is always correct.
- Refer to: STARTUP BATTERY DISCONNECT AND CONNECT
- Refer to: ENGINE COVER - INGENIUM I4 2.0L DIESEL
-
WARNING: Do not work on or under a vehicle supported only by a jack. Always support the vehicle on safety stands.
Raise and support the vehicle.
- Refer to: COOLING SYSTEM DRAINING AND VACUUM FILLING
-
NOTE: This step only applies to vehicles equipped with High Pressure (HP) Exhaust Gas Recirculation (EGR) system.
-
NOTE:
- If equipped.
- Remove and discard the gasket.
- Remove and discard the O-ring seal.
Renew Part: EGR inlet pipe to EGR valve gasket Quantity: 1.
Renew Part: EGR pipe to intake manifold O-ring seal Quantity: 1.
Torque
EGR pipe to EGR valve bolts: 12Nm
EGR pipe to Intake manifold bolts: 7Nm
-
CAUTION: Be prepared to collect escaping coolant.NOTE: If equipped.
-
CAUTION: Be prepared to collect escaping coolant.NOTE: If equipped.
-
CAUTION: Be prepared to collect escaping coolant.
-
CAUTION: Be prepared to collect escaping coolant.
-
CAUTION: Be prepared to collect escaping coolant.
-
CAUTION: Be prepared to collect escaping coolant.
Torque : 12Nm
-
NOTE: Remove and discard the gasket.
Renew Part: Thermostat to cylinder block gasket Quantity: 1.