LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2019 >> XF S >> Repair and Diagnosis >> External Pages >> Different car >> Section 173 (Bumpers -- XE/(760)) >> Bumpers (G1817337) >> Removal And Installation >> Rear Bumper - Project 8 (G2245716) >> Installation

Rear Bumper - Project 8 (G2245716): Installation

WARNING: This page is about a different car, the 2020 Jaguar XE and 2019 Jaguar XE. However, it is still accessible from the selected car via links, so may be relevant.
    • Install the rear valance.
    • Install and tighten the 10 bolts.
    • Install the 2 outside finishers to the rear bumper.
    • Install and tighten the 4 screws.
  3. Install the 4 parking aid sensors.
  4. NOTE: Make sure that all the clips are correctly installed.
    • Install the rear bumper wiring harness.
    • Connect the 4 electrical connectors to the parking aid sensors.
  5. CAUTION: Make sure to protect the paintwork.
    NOTE: Make sure that all the clips are correctly installed.
    • With assistance, install the rear bumper.
    • Position the rear bumper on both sides.
    • Install the 2 upper bolts to the rear bumper.
    • Install the 2 covers.
  7. Install the 4 lower bolts to the rear bumper.
  8. Install the 2 outside screws to the rear bumper.
  9. NOTE: Right side only.
    • Secure the rear bumper wiring harness to the bracket.
    • Connect the electrical connector to the rear bumper wiring harness.
  10. Install the 2 outside bolts to the rear bumper.
  11. NOTE: Repeat the procedure for the other side.

    Install the rear wheel arch liner.

    Refer to: REAR WHEEL ARCH LINER - PROJECT 8

scientia non olet · About LEMON Manuals