DTC B108B-13: Start Button Circuit A - Circuit open: Action
WARNING: This page is about a different car, the 2020 Jaguar XE and 2019 Jaguar XE. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
To validate the repair firstly run the engine for 30 seconds, then use the Jaguar Land Rover approved diagnostic equipment to check this DTC is no longer logged within the body control module
- Refer to the electrical circuit diagrams and check the stop/start switch circuit 1 for open circuit, high resistance. Repair the wiring harness or install a new stop/start switch as necessary