Inspection And Verification
WARNING: This page is about a different car, the 2020 Jaguar XE and 2019 Jaguar XE. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
Diagnosis by substitution from a donor vehicle is NOT
acceptable. Substitution of control modules does not guarantee confirmation of a fault, and may also cause additional faults in the vehicle being tested and/or the donor vehicle.
- Verify the customer concern
- Visually inspect for obvious signs of damage and system integrityTORQUE SPECIFICATION
MECHANICAL ELECTRICAL - Door latch micro switches
- Hood ajar switch
- Passive anti-theft passive sounder (if installed)
- Battery backed sounder (if installed) or battery backed sounder with tilt sensor (if installed)
- Vehicle horns
- Fuse(s)
- Electrical connector(s)
- Volumetric sensor
- Wiring harness
- If an obvious cause for an observed or reported concern is found, correct the cause (if possible) before proceeding to the next step
- If the cause is not visually evident, check for Diagnostic Trouble Code(s) and refer to the relevant Diagnostic Trouble Code(s) (DTC) IndexNOTE: For remote keyless entry system failures:
Refer to: DIAGNOSTIC TROUBLE CODE INDEX - DTC: GATEWAY MODULE (GWM)