Secondary Bulkhead Right Panel - INGENIUM I4 2.0L Petrol (G2020325): Installation

WARNING: This page is about a different car, the 2020 Jaguar XE and 2019 Jaguar XE. However, it is still accessible from the selected car via links, so may be relevant.

1. Install the secondary bulkhead right panel.
2. Install and tighten 5 bolts
  Torque : 5.4Nm
Connect the 2 electrical connectors.
Torque : 3.6Nm
1. Install the engine compartment brace.
2. Install and tighten the 4 bolts.
  Torque : 55Nm
Install the cowl panel.
Refer to: COWL PANEL
Install the engine cover.
Refer to: ENGINE COVER - INGENIUM I4 2.0L PETROL
Connect the startup battery ground cable.
Refer to: STARTUP BATTERY DISCONNECT AND CONNECT