Secondary Bulkhead Right Outer Panel - Project 8 (G2248501): Installation

WARNING: This page is about a different car, the 2020 Jaguar XE and 2019 Jaguar XE. However, it is still accessible from the selected car via links, so may be relevant.

1. Install the secondary bulkhead right outer panel.
2. Install and tighten the 2 bolts.
  Torque : 6Nm
1. Install the retaining clip.
2. Install and tighten the bolt.
  Torque : 6Nm
1. Position the component to the original position.
2. Install the retaining clip.
3. Install the grommet.
4. Connect the brake booster vacuum pipe.
1. Position the engine wiring harness.
2. Install the grommet.
3. Connect the 3 electrical connectors.
  Torque : 8Nm
1. Install the engine compartment brace.
2. Install the grommet.
3. Install and tighten the 4 bolts.
  Torque : 55Nm
Install the cowl panel.
Refer to: COWL PANEL