LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2019 >> XF S >> Repair and Diagnosis >> External Pages >> Different car >> Section 157 (Body Panel System - Front End Body Panels -- XE/(760)) >> Front End Body Panels (G1817284) >> Removal And Installation >> Cowl Panel (G2262108) >> Installation

Cowl Panel (G2262108): Installation

WARNING: This page is about a different car, the 2020 Jaguar XE and 2019 Jaguar XE. However, it is still accessible from the selected car via links, so may be relevant.
  1. NOTE: Only do the following step(s) if the component was previously removed.

    Install and secure the windshield washer hose assembly to the cowl panel.

  2. NOTE: Repeat the step for other side.

    Install and secure the heated windshield washer jet into the cowl panel.

  3. Connect the windshield washer hose to the 2 heated windshield washer jets.
    1. Install the cowl panel.
    2. Install the 12 clips.
  5. NOTE: Repeat the step for other side.

    Connect the electrical connector to the heated windshield washer jet.

  6. NOTE: Repeat the step for other side.

    Install the access cover.

  7. Connect the windshield washer hose.
    1. Reposition the seals.
    2. Install the 2 clips.
  9. Install the windshield wiper pivot arm.

    Refer to: WINDSHIELD WIPER PIVOT ARM

scientia non olet · About LEMON Manuals