LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2019 >> XF S >> Repair and Diagnosis >> External Pages >> Different car >> Section 155 (Electronic Engine Controls - V6 S/C 3.0L Petrol -- XE/(760)) >> Electronic Engine Controls - V6 S/C 3.0L Petrol (G1818564) >> Removal And Installation >> Post Catalyst Heated Oxygen Sensor (G1818208) >> Installation

Post Catalyst Heated Oxygen Sensor (G1818208): Installation

WARNING: This page is about a different car, the 2019 Jaguar XE. However, it is still accessible from the selected car via links, so may be relevant.
  1. CAUTION:
    • If accidentally dropped or knocked install a new Selective Catalyst Reduction (SCR)/Heated Oxygen Sensor (HO2S).
    • Make sure the SCR/HO2s sensor wiring harness is not twisted more than 180 degrees and is not in contact with either the exhaust or driveshaft.
    • Make sure the anti-seize compound does not contact the SCR/HO2s sensor tip.
    NOTE: If the original sensor is to be installed, apply lubricant meeting specification ESE-M12A4-A to the thread of the sensor.
    • Using the special tool install the Heated Oxygen Sensor (HO2S) LH

      Special Tool(s): JLR-303-1666 

      Torque  : 48Nm 

    • Connect the electrical connector and secure the clips.
    • Install the bracket.

      Torque  : 10Nm 

scientia non olet · About LEMON Manuals