LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2019 >> XF S >> Repair and Diagnosis >> External Pages >> Different car >> Section 155 (Electronic Engine Controls - V6 S/C 3.0L Petrol -- XE/(760)) >> Electronic Engine Controls - V6 S/C 3.0L Petrol (G1818564) >> Removal And Installation >> Fuel Rail Pressure Sensor (G1818489) >> Installation

Fuel Rail Pressure Sensor (G1818489): Installation

WARNING: This page is about a different car, the 2019 Jaguar XE. However, it is still accessible from the selected car via links, so may be relevant.
  1. CAUTION: Make sure the threads are clean and free from fuel.
    NOTE: During lubrication, keep the component vertical as shown.
    G11293308Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
    • Lubricate with Molykote W15 as shown.
    • Install the fuel rail pressure sensor.

      Torque  : 35Nm 

  2. Connect the fuel rail pressure sensor.
  3. Install the Noise, Vibration and Harshness (NVH) material.
  4. Install the cowl panel.

    Refer to: COWL PANEL

  5. Install the engine cover.

    Refer to: ENGINE COVER - V6 S/C 3.0L PETROL

  6. Connect the startup battery ground cable.

    Refer to: STARTUP BATTERY DISCONNECT AND CONNECT

scientia non olet · About LEMON Manuals