LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2019 >> XF S >> Repair and Diagnosis >> External Pages >> Different car >> Section 155 (Electronic Engine Controls - V6 S/C 3.0L Petrol -- XE/(760)) >> Electronic Engine Controls - V6 S/C 3.0L Petrol (G1818564) >> Diagnosis And Testing >> Electronic Engine Controls DTC: Heated Oxygen Sensors (HO2S) >> Inspection And Verification >> Notes

Inspection And Verification: Notes

WARNING: This page is about a different car, the 2019 Jaguar XE. However, it is still accessible from the selected car via links, so may be relevant.
  1. Verify the customer concern.
  2. Visually inspect for obvious signs of mechanical or electrical damage.
    VISUAL INSPECTION

    MECHANICAL ELECTRICAL
    • Heated Oxygen Sensor (HO2S) incorrect installation
    • Heated Oxygen Sensor (HO2S) contamination by incorrect fuel or oil
    • Heated Oxygen Sensor (HO2S) degraded
    • Exhaust system leakage
    • Exhaust system restriction
    • Air intake system leakage
    • Mass air flow sensor contamination
    • Incorrect fuel pressure
    • Pipe detached or union leakage between intake manifold and cylinder head
    • Connector is disconnected, connector pin is backed out, connector pin corrosion
    • Fuses
    • Wiring harness
    • Electrical connector(s)
  3. If an obvious cause for an observed or reported concern is found, correct the cause (if possible) before proceeding to the next step.
  4. Using the Jaguar Land Rover approved diagnostic equipment, check for Diagnostic Trouble Codes (DTCs). 
  5. Refer to the DTC help text for diagnostic help specific to the set DTC(s).