LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2019 >> XF S >> Repair and Diagnosis >> External Pages >> Different car >> Section 150 (Engine - V6 S/C 3.0L Petrol -- XE/(760)) >> Engine - V6 S/C 3.0L Petrol (G2289428) >> Removal And Installation >> Oil Pan (G1850993) >> Installation

Oil Pan (G1850993): Installation

WARNING: This page is about a different car, the 2019 Jaguar XE. However, it is still accessible from the selected car via links, so may be relevant.
  1. CAUTION: A new O-ring seal is to be installed.
    G11287029Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

    Renew Part: Oil level gauge O-ring seal Quantity: 1. 

    Torque  : 12Nm 

  2. CAUTION:
    • Make sure that the mating faces are clean and free of foreign material.
    • Use only a plastic scraper when removing the sealing material.
    G11287031Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
    • Apply RTV sealant (Loctite 5901G) in a 2-3mm diameter to the areas shown, and tighten the bolts within 7 minutes.
  3. NOTE: Tighten the bolts in the indicated sequence.
    Fig 1: Oil Pan Extension Bolts Tightening Sequence
    G11287032Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

    Torque  : 12Nm 

  4. G11287027Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
  5. Refer to: ENGINE OIL VACUUM DRAINING AND FILLING 
  6. Connect the battery ground cable.

    Refer to: STARTUP BATTERY DISCONNECT AND CONNECT

scientia non olet · About LEMON Manuals