Left Exhaust Manifold (G2272640): Removal

WARNING: This page is about a different car, the 2019 Jaguar XE. However, it is still accessible from the selected car via links, so may be relevant.

NOTE:

This procedure contains illustrations showing certain components removed to provide extra clarity.
This procedure contains some variation in the illustrations depending on the vehicle specification, but the essential information is always correct.

The following step(s) applies to:

All vehicles

Disconnect the startup battery ground cable.
Refer to: STARTUP BATTERY DISCONNECT AND CONNECT
Raise and support the vehicle on a suitable 2 post lift.
Refer to: LIFTING
Remove the left catalytic converter.
Refer to: LEFT CATALYTIC CONVERTER - RWD

Refer to: LEFT CATALYTIC CONVERTER - AWD
Remove the Air Conditioning (A/C) compressor.
Refer to: AIR CONDITIONING COMPRESSOR - V6 S/C 3.0L PETROL

The following step(s) applies to:

4WD vehicles
Remove the left engine mount.
Refer to: LEFT ENGINE MOUNT

The following step(s) applies to:

Vehicles with Gasoline Particulate Filter (GPF)
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
- Remove the banjo bolt.
- Remove and discard the 2 Gasoline Particulate Filter (GPF) differential pressure sensor washers.
- Remove the 2 nuts from the bracket.
- Reposition the GPF differential pressure sensor away from the exhaust manifold.
The following step(s) applies to:

All vehicles
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
- Remove the air conditioning pipe nut.
- Reposition the pipe away from the exhaust manifold.
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
- Remove the 4 exhaust manifold heatshield bolts.
- Remove the exhaust manifold heatshield.
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
- Disconnect the catalyst monitor sensor electrical connector.
- Release the catalyst monitor sensor wiring from the 3 clips.
NOTE: Make sure that the position of the spacers is noted before removal of the manifold.

Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
- Remove and discard the 6 bolts and remove the 6 spacers.
- Remove the exhaust manifold and discard the gasket.
NOTE: Do not disassemble further if the component is removed for access only.

Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Using the special tool remove the catalyst monitor sensor.

Special Tool(s): 310-121