LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2019 >> XF S >> Repair and Diagnosis >> External Pages >> Different car >> Section 150 (Engine - V6 S/C 3.0L Petrol -- XE/(760)) >> Engine - V6 S/C 3.0L Petrol (G2289428) >> Removal And Installation >> Electric Oil Pump (G1851001) >> Installation

Electric Oil Pump (G1851001): Installation

WARNING: This page is about a different car, the 2019 Jaguar XE. However, it is still accessible from the selected car via links, so may be relevant.
  1. CAUTION: A new O-ring seal is to be installed.
    G11287061Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

    Lubricate the new O-ring seal.

    Renew Part Oil pump O-ring seal Quantity: 1  .

  2. CAUTION:
    • Install the component shown in the sequence shown.
    • Take extra care not to damage the seal when installing the component.
    G11287063Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
  3. CAUTION:
    • Lubricate the oil pump connector bore with clean engine oil. Do not lubricate the O-ring seal.
    • Take extra care when installing the component.
    G11287064Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
  4. CAUTION: Make sure that a new bolt is installed.
    G11287058Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

    Renew Part Oil pump connector bolt Quantity: 1  .

    Torque: 12Nm 

  5. G11287057Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
  6. G11287056Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

    Torque: 25Nm 

  7. G11287055Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

    Torque: 12Nm 

  8. CAUTION: A new O-ring seal is to be installed.
    G11287069Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

    Lubricate the new O-ring seal.

    Renew Part Oil pick up pipe O-ring seal Quantity: 1  .

  9. G11287052Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

    Torque: 12Nm 

  10. G11287071Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

    Torque: 21Nm 

  11. G11286987Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
  12. NOTE: Some variation in the illustrations may occur, but the essential information is always correct.
    G11286988Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

    Using a suitable tool, compress the timing chain tensioner.

  13. CAUTION: Using a suitable tool, lock the component.
    G11287051Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

    Torque: 21Nm 

  14. NOTE: Some variation in the illustrations may occur, but the essential information is always correct.
    • Install the lower timing chain making sure the coloured chain links align correctly with the fuel rail high-pressure fuel pumps camshaft, balance weight and crankshaft sprocket markings.
  15. CAUTION: Take extra care not to damage the oil jet.
    G11287076Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
  16. CAUTION: Take extra care not to damage the oil jet.
    G11287077Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
  17. CAUTION: Use only a long torx socket or torx driver. Do not use a small torx socket, as it may damage the timing chain.
    G11287078Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

    Hold the bolt with a magnet to prevent it from dropping.

    Torque: 10Nm 

  18. G11287079Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
  19. Torque: 12Nm 

  20. G11287081Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

    Rotate the crankshaft a full turn clockwise to settle the components.

  21. G11285450Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

    The piston should apply tension to the timing chain guide.

  22. G11287083Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

    Apply tension then adjust the timing chain guide.

  23. G11287084Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

    The piston should eject slightly, and an audible click should be heard.

  24. G11285451Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

    If the piston can be pushed back, repeat steps 19-22 to reset the tensioner.

  25. G11287086Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

    If the piston will not retract, and tension is on the chain. The tensioner is correct.

  26. G11287043Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

    Hold the bolt with a magnet to prevent it from dropping.

    Torque: 10Nm 

  27. NOTE: Make sure that all traces of the old sealant are removed from the mating faces.
    G11285474Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
  28. G11285475Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

    Apply RTV sealant (Loctite 5901G) to the areas shown, and tighten the bolts within 7 minutes.

  29. CAUTION: Take extra care not to damage the seal when installing the component.
    G11285476Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
  30. NOTE: Tighten the retaining bolts in the indicated sequence.
    Fig 1: Timing Cover Retaining Bolts Tightening Sequence
    G11285477Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

    13

    Torque: 12Nm 

  31. G11285426Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

    Torque: 10Nm 

  32. G11285425Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

    Torque: 10Nm 

  33. G11287037Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
  34. G11287036Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

    Torque: 10Nm 

  35. G11287035Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
  36. G11287034Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
  37. Refer to: OIL PAN EXTENSION 
  38. Connect the battery ground cable.

    Refer to: STARTUP BATTERY DISCONNECT AND CONNECT