Fuel Tank Draining - Project 8 (G2252195): Filling
WARNING: This page is about a different car, the 2020 Jaguar XE and 2019 Jaguar XE. However, it is still accessible from the selected car via links, so may be relevant.
The following step(s) applies to:
All vehicles
- Install a new sealing cap to the fuel drain port.
Renew Part: Fuel tank drain port sealing cap Quantity: 1 .
- Connect the 2 fuel pipes and the electrical connector.
- Install the fuel pump and sensor unit.
- Using the special tool, install the locking ring.
Special Tool(s): 310-123
- Connect the 2 fuel pipes.
- Connect the 2 electrical connectors.
- Install the access cover.
The following step(s) applies to:
Vehicles without seatbelt retention bar
- Install the second row seat cushion.
Refer to: SECOND ROW SEAT CUSHION - PROJECT 8
The following step(s) applies to:
Vehicles with seatbelt retention bar
- Secure the trim panel to the 4 clips.
-
CAUTION: Protect the surrounding paintwork to avoid damage.
With assistance, install the seatbelt retention bar.
- Install the 4 lower bolts to the seatbelt retention bar.
Torque : 30Nm
- Install the 4 upper bolts to the seatbelt retention bar.
Torque : 30Nm
- Secure the 4-point harness to the seatbelt retention bar.
The following step(s) applies to:
All vehicles
- Connect the startup battery ground cable.
Refer to: STARTUP BATTERY DISCONNECT AND CONNECT