Vehicle Inspection (G2148924)

Vehicle inspections may be carried out for various reasons. the following articles provide clarity on specific systems/components that must be checked.

• Inspect windshield, door, tailgate and rear quarter glass for damage.
• Check operation of door locks, hinges, door checks, bonnet catch, fuel flap and charge flap (PHEV vehicles only).
• Check and top-up engine coolant level, Dynamic Response reservoir (if fitted) and windshield washer reservoirs.
• Check and top-up PHEV battery coolant (PHEV vehicles only).

• CAUTION:

  • Brake fluid level should be between MIN and MAX based upon brake pad wear.
  • Only top-up brake fluid level to MAX after new brake pads have been installed.
  • If the brake fluid level is below MIN, visually check for any leaks.

Check brake fluid level.

• NOTE: This inspection is for diesel vehicles fitted with Diesel Exhaust Fluid (DEF) only.

Check the Diesel Exhaust Fluid (DEF) level and top-up as required (Diesel vehicles fitted with DEF only).

• Check condition of accessory drive belt(s).
• Check startup battery and auxiliary battery (if fitted) visual condition and perform a test using the Jaguar Land Rover approved hand-held battery diagnostic tool. Record the resulting battery test code.
• Check condition and operation of the vehicle charging cable (PHEV vehicles only).
• Check expiry date on tire repair system fluid (if fitted).
• Check tire pressures, condition, tread depth, signs of uneven wear and suitability (including spare - if fitted).
• Check security of engine and transmission mounting rubbers.
• Check visually brakes, coolant, fuel and Dynamic Response (if fitted) hoses, unions, and electrical harnesses for chafing, leaks and corrosion.
• Check exhaust system for leaks, security and damage.
• Inspect brake pads for wear, calipers for leaks and discs for condition.
• Connect Jaguar Land Rover approved diagnostic equipment and perform Disc Wear Prediction Algorithm (Jaguar F-Type (X152) Carbon Ceramic Brakes only).
• Check steering and front and rear axle suspension link fixings, check condition of mounting rubbers.
• Check condition of all suspension components, driveshafts and steering boots and gaiters.
• Check steering rod ball joint fixings and condition of ball joints, dust covers and EPAS water drain valve (if fitted).
• Check torque of towbar fixings (Range Rover and Range Rover Sport fitted with multi-height tow bar ball only).
• Clear debris from auxiliary oil cooler and radiator pack (Range Rover, Range Rover Sport and Land Rover Discovery only).