Pre-Test And Functional Checks
WARNING: This page is about a different car, the 2020 Jaguar XE and 2019 Jaguar XE. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
For additional information on systems that must be checked, refer to the relevant article in the repair infomration.
Pre-test and functional checks of systems which affect the safe and legal operations of the vehicle, such as brakes, lights and steering, must be carried out before the road test.
- Check operation of all lamps, horns and warning indicators.
- Check condition and operation of seats, seat belts and mirrors.
- Check condition and operation of windshield, wipers, blades and washer jets.
-
CAUTION:
- Brake fluid level should be between MIN and MAX based upon brake pad wear.
- Only top-up brake fluid level to MAX after new brake pads have been installed.
- If the brake fluid level is below MIN, visually check for any leaks.
Check brake fluid level.
- Check engine oil level.
- Check engine coolant level and PHEV battery coolant level (PHEV vehicles only).
- Check tires, for correct pressure, compatible types and tread patterns, and wear within limits.
- Check there is sufficient fuel in the tank to complete the test.
- Check all around the engine, transmission and under the vehicle for any fluid leak. Make a note of any apparent leaks and wipe off the surrounding areas to make it easier to identify the extent of the leak on completion of the test.