General Procedure - Fluid Leak Detection
WARNING: This page is about a different car, the 2020 Jaguar XE and 2019 Jaguar XE. However, it is still accessible from the selected car via links, so may be relevant.
| SYMPTOM | POSSIBLE CAUSES | ACTION |
|---|---|---|
|
|
|
SERVICE INSTRUCTION
NOTE:
- Slight surface oil dampness without drops are acceptable and should not be repaired as a leak
- Be aware that fluid leaks from above any component may cause oil to collect on the engine and transmission undershield i.e. engine leaks, oil cooler pipe leaks, fuel leaks, coolant leaks
- Fixing the incorrect leak does not satisfy the customer
- Remove any undershield or engine covers to gain access to the suspected leak area REFER to: TRANSMISSION UNDERSHIELD - PROJECT 8 (G2248771)
- Using a suitable degreaser, thoroughly degrease the suspected component all the way around as well as, approximately, 25-50mm (1-2 inches) above the suspected leak
- Using a suitable leak detector spray, thoroughly coat the suspected component as well as, approximately, 25-50mm (1-2 inches) above the suspected leak
- Install the transmission/engine undershield and engine covers if removed REFER to: TRANSMISSION UNDERSHIELD - PROJECT 8 (G2248771)
- Complete a suitable road test and make sure that the engine gets to normal operating 5. temperature
- Remove any undershield or engine covers to gain access to the suspected leak area REFER to: TRANSMISSION UNDERSHIELD - PROJECT 8 (G2248771)
- Inspect the suspected component for fluid leaks, the detector spray should leave a trace from the leak area
Engine oil leak example graphic. Oil is present between the engine and transmission mating faces, including evidence of oil in the 3 breather holes
- Report or repair the source of the fluid leak
- If no leak is found, continue diagnosis until the exact source of the leak is found
- Install the transmission/engine undershield and engine covers if removed REFER to: TRANSMISSION UNDERSHIELD - PROJECT 8 (G2248771)