High Pressure Fuel Pump 2 (G1821202): Removal
WARNING: This page is about a different car, the 2019 Jaguar XE. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
This procedure involves fuel handling. Be prepared for fuel spillage at all times and always observe fuel handling precautions. Failure to follow these instructions may result in personal injury.
CAUTION:
- Do not allow the unions to hit the olive ends of the high-pressure fuel supply line as this may damage the ends of the high-pressure fuel supply line and allow foreign matter to enter the fuel injection system.
- Before disconnecting any components, make sure the area is clean and free from foreign material. When disconnected all openings must be sealed.
NOTE:
Removal steps in this procedure may contain installation details.
-
CAUTION: Make sure to support the vehicle with axle stands.
Raise and support the vehicle.
- Refer to: PETROL AND PETROL-ETHANOL FUEL SYSTEMS HEALTH AND SAFETY PRECAUTIONS
- Refer to: FUEL SYSTEM PRESSURE RELEASE
- Disconnect the battery ground cable.
Refer to: STARTUP BATTERY DISCONNECT AND CONNECT
- Refer to: ENGINE COVER - V6 S/C 3.0L PETROL
- Refer to: RIGHT AIR CLEANER OUTLET PIPE
- Refer to: ENGINE UNDERSHIELD
-
CAUTION:
- Be prepared to collect escaping coolant.
- Before disconnecting any components, make sure the area is clean and free from foreign material. When disconnected all openings must be sealed.
-
CAUTION:
- Be prepared to collect escaping coolant.
- Before disconnecting any components, make sure the area is clean and free from foreign material. When disconnected all openings must be sealed.
- Refer to: FUEL INJECTION COMPONENT CLEANING
-
CAUTION:
- Be prepared to collect escaping fuel.
- Before disconnecting any components, make sure the area is clean and free from foreign material. When disconnected all openings must be sealed.
- This fuel pipe can be re-used, inspect for signs of damage. Renew if necessary.
-
CAUTION:
- Be prepared to collect escaping fuel.
- Before disconnecting any components, make sure the area is clean and free from foreign material. When disconnected all openings must be sealed.
-
WARNING: Do not work on or under a vehicle supported only by a jack. Always support the vehicle on safety stands.
Raise and support the vehicle.
- Refer to: ENGINE OIL VACUUM DRAINING AND FILLING
- Refer to: GENERATOR
- If equipped.
Refer to: HALFSHAFT SUPPORT BRACKET
-
CAUTION: Use a wooden block to protect the oil pan when supporting the engine.
Support the engine.
-
NOTE: Wiring harnesses shown removed for clarity.
-
CAUTION:
- Make sure that the area around the component is clean and free of foreign material.
- Be prepared to collect escaping fuel.
- Before disconnecting any components, make sure the area is clean and free from foreign material. When disconnected all openings must be sealed.
-
CAUTION:
- Make sure that the area around the component is clean and free of foreign material.
- Be prepared to collect escaping fuel.
- Before disconnecting any components, make sure the area is clean and free from foreign material. When disconnected all openings must be sealed.
- Remove and discard the high-pressure fuel supply lines.
Renew Part: Left fuel rail supply pipe Quantity: 1 .
Renew Part: Right fuel rail supply pipe Quantity: 1 .
-
CAUTION: Be prepared to collect escaping oil.
Loosen the Torx screws a turn each at a time.