Secondary Bulkhead Right Outer Panel - Project 8 (G2248501): Installation

WARNING: This page is about a different car, the 2019 Jaguar XE. However, it is still accessible from the selected car via links, so may be relevant.

- Install the secondary bulkhead right outer panel.
- Install and tighten the 2 bolts.
  Torque: 6 Nm
- Install the retaining clip.
- Install and tighten the bolt.
  Torque: 6 Nm
- Position the component to the original position.
- Install the retaining clip.
- Install the grommet.
- Connect the brake booster vacuum pipe.
- Position the engine wiring harness.
- Install the grommet.
- Connect the 3 electrical connectors.
  Torque: 8 Nm
- Install the engine compartment brace.
- Install the grommet.
- Install and tighten the 4 bolts.
  Torque: 55 Nm
Install the cowl panel.
Refer to: COWL PANEL .