LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2019 >> XF S >> Repair and Diagnosis >> External Pages >> Different car >> Section 142 (Body Panel System - Front End Body Panels) >> Front End Body Panels (G1817284) >> Removal And Installation >> Hood Latch Panel - Project 8 (G2249571) >> Installation

Hood Latch Panel - Project 8 (G2249571): Installation

WARNING: This page is about a different car, the 2019 Jaguar XE. However, it is still accessible from the selected car via links, so may be relevant.
    • Install the hood latch panel.
    • Install and tighten the 4 bolts.

      Torque: 25 Nm 

  2. NOTE: Repeat this step for the other side.
    • Install the bracket.
    • Install and tighten the 2 bolts.

      Torque: 25 Nm 

    • Install the bracket.
    • Install and tighten the 4 bolts.
    • Install and tighten the nut.

      Torque: 10 Nm 

    • Install the bracket.
    • Install and tighten the 4 bolts.

      Torque: 10 Nm 

    • Install and tighten the nut.

      Torque: 10 Nm 

    • Release the trim.
    • Install the air intake.
    • Secure the 4 clips.
    • Secure the clip and connect the electrical connector.
    • Install the right hood latch.
    • Install and tighten the 2 bolts.

      Torque: 10 Nm 

    • Secure the cable.
    • Install the left hood latch.
    • Install and tighten the 2 bolts.

      Torque: 10 Nm 

    • Secure the cable.
  8. NOTE: Repeat this step for the other side.
    • Install and tighten the bolt.

      Torque: 10 Nm 

scientia non olet · About LEMON Manuals