Hood - Project 8 (G2249569): Installation

WARNING: This page is about a different car, the 2019 Jaguar XE. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Only do the following step(s) if the component was previously removed.
- Install the hood vent.
- Install and tighten the 16 nuts.
  Torque: 7 Nm
- Install the 4 bump stops.
- Install the 2 strikers.
- Install the hood safety catch assembly and secure the cables with the 6 clips.
- Install and tighten the 10 bolts.
  Torque: 10 Nm
NOTE: Do not tighten the nuts at this stage.
- With assistance, install the hood.
- Install the 6 nuts.
- Secure the 2 struts.
Align the hood.
Refer to: HOOD ALIGNMENT - PROJECT 8 .