Electric Park Brake Release (G2219524): Check

CAUTION: This procedure requires the vehicle in the Park or Neutral position, with the ignition turned ON and the parking brake system released.

NOTE:

This procedure contains some variation in the illustrations depending on the vehicle specification, but the essential information is always correct.
This procedure contains illustrations showing certain components removed to provide extra clarity.

NOTE:
- This procedure allows the parking brake to be released when removing and installing new rear brake pads or brake discs.
- An audible noise will be heard to confirm that the parking brake has been set to Service Mode.
- Press and hold the parking brake switch in the release position.
- Wait 1 second.
- Press and hold the accelerator pedal in the wide open throttle position.
- Wait 1 second.
- Turn the ignition Off and back On immediately.
- Release the accelerator pedal and release the parking brake switch to the neutral position.
NOTE: An audible noise will be heard to confirm that the parking brake has been released from the Service Mode.
- Press and hold the parking brake switch in the apply position.
- Wait 1 second.
- Press and hold the accelerator pedal in the wide open throttle position.
- Wait 1 second.
- Turn the ignition Off and back On immediately.
- Release the accelerator pedal and release the parking brake switch to the neutral position.