Instrument Cluster (G2219031): Installation

- Connect the 3 electrical connectors.
- Secure the 4 clips.
- Install the instrument cluster assembly.
- Install and tighten the 4 screws.
  Torque : 1.5Nm
NOTE: Make sure that the trim is correctly installed to the retaining clips.
- Install the instrument cluster surrounding trim panel.
- Secure the 4 clips.
- Install and tighten the 3 screws.
  Torque : 1.5Nm
- Install the access cover.
NOTE: Make sure that the trim is correctly installed to the retaining clips.
- Install the trim panel.
- Secure the 4 clips.
Install the In-vehicle temperature sensor.
Refer to: IN-VEHICLE TEMPERATURE SENSOR .
Install the center vent trim panel.
Refer to: CENTER VENT TRIM PANEL .
Install the driver side face level vent.
Refer to: DRIVER SIDE VENT .
CAUTION: Only applicable vehicles with software numbers K8D2-14C104-AC or L8B2-14C104-AC as detailed in removal step 1 .
NOTE:
- Only complete this step if a new instrument cluster is to be installed.
- This step is only applicable to 19MY onward vehicles.
- Non-NAS Markets only.
- SRO must be claimed separately.
Install a new RFA .

Refer to: REMOTE FUNCTION ACTUATOR .
NOTE:
- This step is only required if a new component is installed.
- SRO to be claimed separately.

Use the Jaguar approved diagnostic equipment to configure the new module.
General Equipment: Jaguar diagnostic equipment
Follow all on-screen instructions to complete this task.