LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2019 >> F-Pace Base >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Transmission/Transaxle Cooling - INGENIUM I4 2.0L Diesel, Vehicles With: 8HP70 8-Speed Automatic Transmission AWD/8HP45 8-Speed Automatic Transmission AWD/8HP45 8-Speed Automatic Transmission RWD -- F-Pace (X761)) >> Transmission/Transaxle Cooling - INGENIUM I4 2.0L Diesel, Vehicles With: 8HP45 8-Speed Automatic Transmission AWD/8HP45 5-Speed Automatic Transmission RWD/8HR70 8-Speed Automatic Transmission AWD (G1862975) >> Removal And Installation >> Transmission Fluid Cooler Pipes - INGENIUM I4 2.0L Diesel (G1817253) >> Installation

Transmission Fluid Cooler Pipes - INGENIUM I4 2.0L Diesel (G1817253): Installation

WARNING: This page is about a different variant/trim than selected.
  1. Install the transmission cooler tubes.
  2. CAUTION: Install new O-ring seals.
    • Install new O-ring seals to the transmission cooler tubes.

      Renew Part: Transmission fluid cooler tubes to transmission O-ring seals  Quantity: 1. 

    • Install and tighten the bolt securing the transmission fluid cooler tubes to the transmission assembly.

      Torque  : 22 Nm 

  3. Install and tighten the bolt securing the transmission fluid cooler tubes to the oil pan assembly.

    Torque  : 11 Nm 

  4. Install the 2 transmission cooler tubes to the transmission cooler assembly.
    • Install the front left lower fender splash shield.
    • Install the 3 clips securing the lower fender splash shield to the vehicle body.
  6. Fill the transmission fluid.

    Refer to: TRANSMISSION FLUID LEVEL CHECK .

  7. Lower the vehicle.
scientia non olet · About LEMON Manuals