Static Apply/Release

Static Apply 

For the static apply mode to operate, the ignition can be on or off. When the Electric Park Brake (EPB) switch is pulled up, the Anti-lock Brake System (ABS) control module activates the two EPB actuators to apply the brakes and it signals the Instrument Cluster (IC) to turn on the EPB indicator lamp. The warning indicator stays on continuously while the ignition is on, and it stays on for 30 seconds after the ignition is switched off.

Static Release 

For the static release mode to operate, the ignition must be on with either the brake, clutch or accelerator pedal pressed. When the EPB switch is pressed down, the ABS control module activates the two EPB actuators to release the brakes. The ABS control module signals the IC to turn off the EPB indicator lamp.