Brake Pads - INGENIUM I4 2.0L Diesel/INGENIUM I4 2.0L Petrol/TDV6 3.0L Diesel/V6 S/C 3.0L Petrol (G1822059): Installation

WARNING: Do not use compressed air to clean brake components. Dust from friction materials can be harmful if inhaled.

Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Clean the brake caliper housing and anchor plate using brake cleaning fluid.
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Inspect the caliper piston and slide pin seals for damage.
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Push the brake caliper pistons back.
Install the brake pads.
CAUTION: Make sure that the brake hose is not twisted and is correctly located.

NOTE: Inspect the brake pad wear sensor for signs of wear or damage. Install a new sensor if necessary.
- Install the brake caliper.
- Install the 2 slide pins.
  Torque: 28 Nm
- Install the 2 dust covers.
Install the spring.
Install the rear wheel.
Refer to: WHEEL AND TIRE - INGENIUM I4 2.0L DIESEL/INGENIUM I4 2.0L PETROL/TDV6 3.0L DIESEL/V6 S/C 3.0L RETROL (G1967109)
Repeat the above procedure for the other side.
Depress the brake pedal several times, check the fluid level in the brake fluid reservoir and top-up with brake fluid if necessary.
Calibrate the electric parking brake (EPB) using the diagnostic tool.
NOTE: This step is only required if the diagnostic tool is not available.

Refer to: ELECTRIC PARK BRAKE SERVICE MODE ACTIVATION AND DEACTIVATION
NOTE: This step is only required if the vehicle has no battery power.

Refer to: ELECTRIC PARK BRAKE RELEASE WHEN THE VEHICLE HAS NO ELECTRICAL ROWER (G1822068)