Rear Upper Control Arm (G2187518): Installation

CAUTION: Make sure that new nuts and bolts are installed.
- Install the rear upper control arm.
- Install the 2 bolts and the 2 nuts.
  Renew Part: Upper control arm retaining nut and bolt Quantity: 1 .
- Tighten the 2 nuts.
  Torque
  
  Stage 1: 40 Nm
  
  Stage 2: 180°
Install the rear wheel and tire.
Refer to: WHEEL AND TIRE .
NOTE: Using Jaguar Land Rover approved equipment, check and if necessary adjust the wheel alignment. SRO must be claimed separately.

Check the wheel alignment and adjust if required.

Refer to: WHEEL ALIGNMENT .