Turbocharger Oil Supply Tube (G2110435): Removal

WARNING: Observe due care when working near a hot exhaust system.

CAUTION: All precautions should be taken to avoid any oil or coolant contaminating the accessory drive belt or pulleys. If the accessory drive is contaminated with oil or coolant, clean the pulleys and install a new accessory drive belt.

NOTE:

Some variation in the illustrations may occur, but the essential information is always correct.
Some components shown removed for clarity.

Raise and support the vehicle on a suitable 2 post lift.
Refer to: LIFTING .
Partially drain the cooling system.
Refer to: COOLING SYSTEM PARTIAL DRAINING AND VACUUM FILLING .
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Remove the noise, vibration and harshness (NVH) material.
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Remove the coolant hose.
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Remove the banjo bolt.
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Disconnect one electrical connector.
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Remove the banjo bolt.
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Remove the turbocharger oil supply tube from the vehicle.