DTC P2176-51: Throttle Actuator, A, Control System - Idle Position Not Learned - Not programmed: Action
WARNING: This page is about a different car, the 2018 Jaguar XE. However, it is still accessible from the selected car via links, so may be relevant.
- Vehicle Conditions to enable DTC Logging Strategy
- Ignition Off - On and wait 60 seconds prior to starting engine, adaptation will be performed if entry conditions are present
- Check battery is in fully charged and in a serviceable condition using a battery tester and battery care manual
- Allow powertrain control module to power down. Turn on ignition and wait for 60 seconds. Start engine, this will allow new throttle adaptation data to be stored
- Using the Jaguar Land Rover approved diagnostic equipment, clear the DTCs and retest