Removal And Installation: Installation

WARNING: This page is about a different car, the 2018 Jaguar XE and 2017 Jaguar XE. However, it is still accessible from the selected car via links, so may be relevant.

Install the turbocharger wiring harness.
NOTE: This step is only required if previously removed.
- Install the turbocharger.
- Install a new gasket.
  Renew Part: Turbocharger to exhaust manifold gasket Quantity: 1
- Torque: 28 Nm
Connect the turbocharger electrical connector.
- Install the turbocharger oil return pipe. ? Torque: 12 Nm
- Install new O-ring seals.
  Renew Part: Turbocharger oil return pipe seals Quantity: 2.
- Torque: 12 Nm
- Install the turbocharger oil supply pipe. ? ?
- Install new sealing washers.
  Renew Part: Turbocharger oil feed pipe banjo bolt washers Quantity: 2.
- Install a new banjo bolt.
  Renew Part: Turbocharger oil feed pipe banjo bolt Quantity: 1
  
  Torque: 18 Nm
- Secure the catalytic converter to the turbocharger. ? ?
- Install a new gasket.
  Renew Part: Exhaust pipe to turbocharger gasket Quantity: 1.
- Install a new clamp.
  Renew Part: Front exhaust clamp Quantity: 1.
  
  Torque: 10 Nm
Install the catalytic converter to cylinder head mounting bracket.
Torque: 25 Nm
Install the turbocharger heatshields.
Torque: 8 Nm
Install the exhaust gas temperature sensor.
Refer to: Exhaust Gas Temperature Sensor - Ingenium I4 2.0L Diesel .
Secure the catalytic converter to the transmission bracket.
Torque: 25 Nm
Install the charge air cooler intake pipe.
Torque: 12 Nm
Install the air deflector.
Refer to: Air Deflector .
Install the low pressure Exhaust Gas Recirculation (EGR) valve.
Refer to: Low Pressure Exhaust Gas Recirculation Valve .
Connect the battery ground cable.
Refer to: Battery Disconnect and Connect .