Removal And Installation: Removal

WARNING: This page is about a different car, the 2018 Jaguar XE and 2017 Jaguar XE. However, it is still accessible from the selected car via links, so may be relevant.

WARNING:

Wait for a minimum of 1 minute after the engine has stopped before carrying out any repair to the fuel injection system.
Avoid flames, sparks or lighted substances.
Place the vehicle in a well ventilated, quarantined area and arrange ' No Smoking/Petrol Fumes' signs about the vehicle.

CAUTION: Before disconnecting or removing components, ensure the area around the joint faces and connections are clean. Plug open connections to prevent contamination.

NOTE:

Some variation in the illustrations may occur, but the essential information is always correct.
Some components shown removed for clarity.
Removal steps in this procedure may contain installation details.

Refer to: Petrol and Petrol-Ethanol Fuel Systems Health and Safety Precautions .
Refer to: Engine Cover - V6 S/C 3.0L Petrol .
Refer to: Fuel System Pressure Release .
Refer to: Battery Disconnect and Connect .
Refer to: Secondary Bulkhead Panel LH - V6 S/C 3.0L Petrol .
Refer to: Secondary Bulkhead Panel RH - V6 S/C 3.0L Petrol .
Raise and support the vehicle.
Refer to: RIGHT CATALYTIC CONVERTER .
Refer to: Generator .
Refer to: Starter Motor .
Torque: 11 Nm
Torque: 11 Nm
WARNING: Be prepared to collect escaping fuel.

CAUTION: Make sure that all openings are sealed. Use new blanking caps.

Torque: 21 Nm
WARNING: Be prepared to collect escaping fuel.

CAUTION: Make sure that all openings are sealed. Use new blanking caps.
NOTE: Note the orientation of the component prior to removal.

Inspect the component and install a new one if damaged.